Asked by: Abubacar Baschasked in category: General Last Updated: 22nd May, 2020
Is there a reset button on a Fisher and Paykel washing machine?
Similarly, how do you troubleshoot a Fisher Paykel washing machine?
How to Troubleshoot Fisher Paykel Washers
- Check the hot water light.
- Check the cold water light.
- Check both the hot and cold water lights.
- Check the high water light.
- Look at the first rinse light and spin light.
- Examine the lid-lock light.
- Look at the first rinse light, the spin light and the spin speed light.
Beside above, how do you run a diagnostic on a Fisher Paykel washing machine? Turn the power on at the power point but off at the machine. Press and hold the WASH TEMP DOWN button and then the POWER button until the machine gives 2 short beeps and lights up. Release buttons when the beeps indicate diagnostic mode has been entered. The SmartDrive is now in diagnostic mode.
Then, why is my washing machine not turning on?
The lid switch is under the lid. If your washer will not start, be sure the switch is being pressed. If the lid switch is being pressed but no power is being supplied to the washers motor, then the switch is most likely bad. To test the switch, turn off power to washer and remove the wires from the lid switch.
How do I reset my washing machine?
To perform the Master Reset, carefully unplug the washing machine from the power outlet and leave it unplugged for one minute. After one minute is up, plug the washer cord back into the wall. Next, open and close the door of the washing machine 6 times within 12 seconds to send a “reset” signal to all the components.